Peugeot 308 Key Fob Problems and How to Fix Them
If your Peugeot 308 key fob has stopped functioning one day it could be due to a dead battery in the coin or water damage the receiver module or a faulty electronic chip. These are all easy solutions that will restore your car to speed in no time!
The key blade may become worn out and cause a faulty car key. It is easy to fix when you visit your local Car Key Man Auto Locksmith and let them install the new key blade for you.
Battery
The key fob of your Peugeot 308 may die or become weak enough to not send a clear signal. This can cause the key fob to stop functioning and prevent you from locking or opening the doors, or even starting your engine. You'll need a replacement battery for your key fob to correct this.
You can purchase a new battery at an auto parts shop, or at your local hardware store. When you purchase the battery ensure that it's new and hasn't been on the shelf for a long time. A new battery has more capacity and will transmit a stronger signal your vehicle.
After replacing the battery Try locking and unlocking the doors of your Peugeot by using the key fob. If the doors aren't unlocking the issue is likely to be in the receiver module of the car, which can be reprogrammed by your local Peugeot dealer.
The internal chip of the key fob might be damaged. It's possible to damage your key fob if you drop it on the ground, or expose it to water. The rubber seals that shield the chip from moisture can wear down over time, particularly if the key fob is exposed to water for long periods of time like submerging it in the ocean at the beach. To avoid this you should keep your key fob clear of water and out of water.
Water Damage
Don't give up on your key fob when it gets wet, regardless of whether you dropped in the pool or slipped into a Puddle. While the key fob has rubber seals that protect it from water, long-term exposure to water may lead to damage to its electronic chip. Water is a great conductor, and any water that is absorbed into the key fob will cause short circuits in series, which will eventually ruin the electronic chip. After removing the batteries clean the contacts with isopropyl, and then dry them completely before putting them back into.
A dead battery could be the reason that your Peugeot 308 won't start. If you have a spare car, jumper cables can be used to get the engine going again. If the battery is defective, it must be replaced.
Another reason could be a defective receiver inside the vehicle that could hinder it from receiving a signal from the key fob. The key fob might be damaged or there may be an issue with the antenna, wiring or even the key fob itself. It is possible to programme a new key fob to your vehicle if you are using one. If you're not able to solve the issue, you should contact an expert technician. A technician trained in the field will be able to diagnose the problem quickly, and resolve it quickly.
Radio Interference
The signs of a key fobs not being recognized or having a restricted range of operation usually mean there is an interference in the system. This can be either radiated, or conducted, with the former being caused by power supply cables and speaker wiring passing too close to electrical components. In general, rerouting cables or moving them away from these components will fix the issue.
It's unlikely that someone is listening in on the key fob's signals to steal your car, but it's possible that your signal has been drowned out by radio frequency interference. This is a straightforward issue to resolve.
If click through the following page is not being recognized by the system, try a new battery. Make sure that the battery is the right size and type. Batteries of the wrong size can cause damage to your device.
Certain alarm systems and radar detectors use the same radio frequency as your key fob which can cause them to interfere with your key signals. Avoid attaching these devices to your key fob.
Pairing Issues
The remote keyless entry system includes an antenna that receives radio frequency signals from the key fob. You will not be able start your car if this receiver is not functioning properly, even if your key fob works and is reprogrammable. The issue can be caused in a number of ways, such as a dead coin-cell battery or water damage. The receiver may also be malfunctioning due to a software error or internal damage in the key.
One of the main reasons for why your Peugeot 308 key fob isn't functioning is that the battery inside has died. This battery can be replaced, but you must ensure that it's the correct battery for your key fob. The wrong battery could cause more problems with the key fob, so it is recommended to use the original or an equivalent replacement in size, voltage and specifications.
Your Peugeot 308 keyfob may not work if it has been associated with a different vehicle. You could have accidentally handed your key fob to someone else or the key was used to unlock other vehicles. This can be resolved by reprogramming your key fob using an OBDII scan. This tool will ask for details about your car, like its VIN or engine type. It is important to enter the correct details.